After the string has been threaded through the exit hole, place it back into the hub of the weed eater and make sure the notch is aligned with the hole the string came out of.Observe how the string goes through the exit hole by looking at the picture that is included in the References part of the weed eater owner’s handbook.Put some force on the spool, and then push it all the way into the hub.
Can you replace the string on a weed eater?
It is not necessary to take any additional or different procedures in order to replace the string on the weed eater; all you need to do is follow the instructions that I provided before in order to thread the trimmer for the first time.When it comes to replacing the string, on the other hand, you have the option of either switching out the complete spool or keeping the one you have and only replacing the thread.
How to string Echo weed eaters?
Echo Weed Eater Stringing Instructions 1 To begin, make sure the arrow on the spool is pointing in the same direction as your hole. 2 Thread 15–20 feet of line through the eyelet and hole in the shackle; then, draw the line taut and check to see that both sides are the same length. 3 When you have finished loading the line, rotate the head until the line is completely loaded.
How to use a weed trimmer?
The head of the majority of weed trimmers may be unscrewed in order to expose the spool of string that is housed inside.It is recommended that you read the instructions that are located on the unit in order to establish in which direction the head of the gadget should be turned.After giving it a delicate twist, you will be able to see the spool of thread that is still there.The remaining portion of the spool is permanently fastened to the weed eater, making it impossible to remove it.
How do you put string in a double line weed wacker?
While you are putting the spools back in the trimmer head, there should be two retainers to hold the 5″ or 6″ residual bits of string in place.These pieces should be around half an inch long.In addition, the double-line weed wacker features two eyelets on the sides of the trimmer head rather than slots on the same sides.After you have threaded each of the two lines through its respective eyelet, place the spools into the trimmer head.
Why does my weed eater string keep getting stuck?
If the line of a Weed Eater trimmer head is too short, then an insufficient amount of centrifugal force will operate on it, preventing it from advancing. If you do not tap the head frequently enough or if the line is cut by anything like a piece of wire or a root, you may find yourself in this predicament.
What size string does a Dewalt Weed Eater use?
It features two cutting lines that are 0.080 inches in width and a head that is 13 inches in diameter. This DeWalt string trimmer operates off of a battery and has a voltage of 20 volts. It has a straight shaft and weighs 8.5 pounds.