Unthreading the head from where it is threaded onto the end of the shaft is all that is required to remove the head from your Weed Eater.Position the Weed Eater trimmer so that it is lying on its side on a level surface, with the air filter cover facing in the other direction.While you are removing the trimmer head, you should use an adjustable wrench to secure the dust cup nut so that the shaft does not slide.
How do you clean a craftsman weed trimmer head?
Stop using your weed trimmer and let it cool down fully before putting it away. Grass clippings and other debris may be removed from the trimmer head by using a shop towel to clean it off. Take off the bump knob that is located on the underside of the trimmer head. Take the spool of line that is attached to the trimmer out of the trimmer head.
How to use a weed eater?
Both the interior and exterior surfaces of the trimmer head of the weed eater should have a small hole in them. In order to maintain the head’s position while the middle nut is being removed, insert the screwdrivers with the very small heads into both of the holes.
How do you remove the head from a Phillips Trimmer?
With the use of an adjustable wrench, take off the middle nut. The head of the trimmer may then be removed by simply pulling it off. Remove the head of the trimmer by first using a screwdriver to loosen it off the shaft, and then pulling it out entirely if the trimmer does not have the two very small holes for the Phillips head.
How do you remove the head of a Craftsman weed eater?
How can I disconnect the head from my Craftsman line trimmer?
- Turn off your trimmer and disconnect it from any power sources it may be connected to
- Invert the trimmer so that the head is pointing in your direction
- Turn the trimmer on its side.
- Holding down each tab simultaneously will separate the head of the trimmer from the remainder of the trimmer
How do you take the cap off a weed wacker?
If the cover doesn’t contain a nut, you should rest your hand on the cover itself. Put your fingertips over the cover so that you can feel the two tabs that are located on opposing sides of the cover. Pull up on the lid while simultaneously squeezing the tabs together to open the package. The cover ought should peel off without any difficulty.
Where is the model number on a Craftsman Weedwacker?
On a tag that is fastened to the housing of the trimmer, which is the part that covers the engine, the model and serial number are written. In order to locate the tag, you may need to clean the housing of the trimmer. When you clean the item, the tag will not come off since it is constructed of a material that is resistant to water.